GD427 in action

GD427 in action

Sunday 31 July 2011

A few more bits and pieces

Finished off a few more bits this weekend. First off I finished fitting all the body mounts bolts ensuring they weren't too long and rubbing on the chassis. Where the tolerance was a little close I just used another washer to space the end of the bolt away from the chassis. I also trial fitted the stainless mesh in the front of the hood scoop. Becasue of the style of engine I'm using, the scoop itself is just for aesthetics and serves no purpose other than looking great ! I haven't cut the front out of the scoop but instead painted it matt black and then fitted the mesh across the front to match the oil cooler and brake ducts.



At long last I fitted the drivers door, this always caused me a few problems in the past as I couldn't quite get the top bolt through the hinge plate, I must be on a roll as this time I tried it went together almost straight away. I also had a little trail run with the polishing machine which is why this door looks a little shinier than the rest of the car.




Lastly I trial fitted ( a lot of stuff's trial fitted :-) ) some stainless steel rings I had made up by a friend from the owners club. Thanks Steve! The top ring will be used to trap a large rubber boot/gaiter I'm going to use to cover the main engine loom as it passes from the engine bay through the bulkhead to the rear of the dash. I'll probably rig up something similar for the smaller hole which is used for things such as the oil pressure line and washer bottle hose. The rings were made in identical pairs and each have another behind the bulkhead sandwiching the bulkhead between them. I may just use some 1mm rubber sheet sandwiched between the rings with a small hole cut in the middle for the wires to pass through. A little trial and error is needed to determine what works best.



No comments: