After my first attempt at rigging up some battens to assist with marking the holes on the screen support legs I went back to the drawing board and built something a little more substantial. This time it worked like a dream and made transferring the fixing holes to the legs childs play. The next part was not quite straighforward as we had terrible trouble drilling the legs themselves. I had thought this part would be relatively easy but despite having a good set of drill bits, a drill press and clamp, the bit was snatching in the material and making a right old mess. Luckily we had started with a small drill as a pilot and were gradually moving up in size so whilst it was a bit worrying and quite honestly frustrating, we hadn't done any damage. We had no option but to down tools and take some time out. Whilst having a cup of tea I turned to the internet and posted a quick message on the Cobra Club Forum asking for some guidance. Within a few moments we had our answer, we were using too slow a drill speed. My thanks to "Toddy" for putting me straight. Unfortunately Dad had to leave so he never got to see the progress I made once I upped the drill speed. Here's a few photos, partly to record my progress for the blog but also to show Dad what I got up to after he left.
Having got the holes drilled in the windscreen support legs and got the screen mounted, my thoughts turned to the bonnet scoop. I had previously spent some time marking a centre line on the bonnet and after making a paper template of the scoop, cutting it out and folding in half, I aligned the centre of the template with the centre of the bonnet and marked it's outline onto the bonnet in preparation for the scoop itself.
Time was getting on by now and I wasn't going to get the scoop finished but partly to see what it looked like mounted and partly to keep it somewhere safe where it couldn't get damaged I drilled three of the mounting holes and bolted it on.
No comments:
Post a Comment